Inicio > Portafolio > Straighteing and Cutting Machine for Wire > STRAIGHTENING MODEL EC RH
STRAIGHTENING MODEL EC RH
|
MODEL |
EC-15RH |
EC-28RH |
EC-38RH |
EC-45RH |
|
Max diameter inlet (mm) |
15,00 |
28,0 |
38,0 |
45,0 |
|
Min diameter outlet (mm) |
5,0 |
15,0 |
15,0 |
20,0 |
|
Max speed (m/min) |
60 |
45 |
45 |
30 |
Are especially suitable for processing raw solid wires without calibration, since the system itself ,make a slightly laminated surface. Its use is also recommended for straightening tubes.
Straightness tolerance (0.5 mm for lengths of 500 mm (EN 10218-2))
Cutting tolerance (0.5 mm to less than 1,000 mm of lengths (EN 10218-2))
Cutting length (minimum 25 mm (with hydraulic shears). Maximum according to table collection. Normally between 1-5 m length)
